Skip to content

RCU Tester: Automated testing for TV and set-top box remote controls

Remotes are scrapped for a stuck button or a dim LED because nobody tests them properly. The RCU Tester presses every key, checks IR at three angles, pairs Bluetooth, and tests the microphone in about a minute.

RCU Tester
  1. ~60sec

    Average test per remote

  2. 100%

    Of buttons pressed and validated

  3. 3

    IR angles checked

    0°, +30°, and -30°

  4. ~6m

    Simulated living-room range

    Through an ND filter

Most recovery systems are not built for accessory testing. Without the right tools, remotes are scrapped for minor issues or simply because nobody validated them, and manual checks are inconsistent. The RCU Tester automates the whole process.

  • Buttons Pneumatic pushers press every key.
  • IR output Three IR receivers confirm signal strength at multiple angles.
  • Range An ND filter simulates use from about 6 meters.
  • LEDs Optical fibers and a camera confirm light output.
  • Bluetooth Pairing is validated through a connected set-top box.
  • Microphone Tested with speaker input and the set-top box’s response.

Failures are logged by button or function for a precise diagnostic trail.

Separating functional validation from cosmetic grading means working remotes are not scrapped for superficial reasons. Programs get faster kitting turnaround, lower replacement costs, less scrap, and the same test standard at every site.

  • Golden sample calibration Each model fixture is verified before production.
  • Audit-ready logs Serials, timestamps, operators, and outcomes.
  • ERP integration Logs export for QA, resale, or rebuild programs.
  • Cross-site sync The same thresholds at every facility.

How the RCU Tester works

  1. Place

    The remote goes face down, batteries out, in a model-specific fixture.

  2. Power

    A battery probe lowers and powers the remote.

  3. Test

    Every button is pressed, IR validated at three angles, Bluetooth pairing checked, the microphone tested through the set-top box, and LEDs confirmed.

  4. Grade and route

    Pass in green or fail in red with details. Validated units move on to kitting or refurbishment.

Common questions

How is every button tested?

Pneumatic pushers press each button in turn, and every press is validated by IR receivers at three angles, so weak or misaligned signals are caught. A failure is logged with the exact key and reason.

How is real-world range simulated?

An absorptive ND filter between the remote and the receivers cuts beam intensity about 70 times, replicating use from around 6 meters rather than point-blank.

Can Bluetooth and voice remotes be tested?

Yes. The remote pairs with a set-top box to validate Bluetooth. For voice remotes, a speaker in the fixture plays a prompt and the system checks that the microphone carries it to the set-top box.

How are results kept accurate?

Before production, each model fixture is verified with a known-good golden sample, so pneumatics, sensors, and optics are aligned. Every test is then logged with serial, timestamp, operator, and result.

What does setup need?

Compressed air at 5.6 bar, a LAN connection, and a dedicated set-top box with internet and HDMI. Each remote model needs its own fixture, and the touchscreen walks operators through model selection, calibration, and testing.

Other Tech Solutions

Pegasus

Pegasus: AI-Driven Optical Receiving

Optical receiving that identifies products, reads part numbers, captures condition, and creates an image-verified record for every unit.

Ready to recover the remotes others discard?